
What gets reported
Audio faults come in a few forms: the tenant can hear the visitor but not the other way round; both sides get crackle or a loud hum; the sound is too faint to use; or tenants hear other apartments' visitors as well as their own.
Which form you have points to where the fault is, so it helps to note it before you call.
The usual causes
- The speaker or microphone in the entry panel has corroded. The panel sits outdoors or in a damp vestibule. When visitors can't be heard by anyone in the building, this is the usual cause.
- One apartment station's speaker or microphone has failed. If only one unit has the problem, the fault is in that station or its handset cord.
- Wires are crossed or shorted. Hearing other apartments' conversations, or a hum that starts when a button is pressed, means two wires are touching somewhere.
- The amplifier is failing. Faint sound across the whole building, or sound that fades in and out, points to the amplifier.
- Something is interfering. A loud steady hum can come from a failing power supply or from intercom wire run alongside power cable.
What the super can check first
- Note which direction fails: the tenant can't hear the visitor, the visitor can't hear the tenant, or both.
- On handset stations, check the coiled cord is pushed fully in at both ends.
- Check the station's volume control, if it has one.
- Call two or three other units from the door. If nobody can hear visitors, the fault is at the entry panel.
Building staff shouldn't open the lobby panel or the amplifier cabinet. The wiring is low voltage, but the power supply that feeds it is not, and a crossed wire can take out every apartment on the line.
How we fix it
We test the entry panel's speaker and microphone first, because one failed part there affects every apartment. Then we check the amplifier output and the line to the affected stations.
Panel speakers and microphones are replaced inside the existing panel. A failed station or handset is replaced. Crossed wires are traced and separated. A weak amplifier is repaired or replaced.
What it costs
Most audio repairs cost $200 to $400. Tracing crossed wires through a building can take longer and cost more, so contact us for a price.
Repair or replace?
A corroded panel speaker or a dead handset is a repair. If the panel is corroded throughout, replacing the panel on the existing wiring is often better value than replacing its parts one at a time.
Common questions
Why can tenants hear other apartments on the intercom?
Two lines are touching, usually where wires share a conduit or at a station that was wired wrongly. It's a privacy problem as well as a nuisance, so it's worth fixing promptly.
The intercom hums all the time. Is that dangerous?
It isn't dangerous, but a constant hum usually means the power supply is failing, and the system may stop altogether.
Visitors say a tenant sounds far away. What causes that?
A weak microphone in that station, or a failing amplifier if other units get the same complaint.
Does rain affect the intercom?
Yes. Water in an outdoor panel causes crackle and silence that come and go with the weather. The fix is to replace the damaged parts and reseal the panel.
